• Source: Area codes 214, 469, 972, and 945

Area codes 214, 469, 972, and 945 are telephone area codes in the North American Numbering Plan (NANP) for Dallas, Texas and most of the eastern portion of the Dallas–Fort Worth metroplex. The area codes are assigned in an overlay complex to a single numbering plan area that was the core of one of the original area codes of 1947, area code 214.




History


The original configuration of the nationwide telephone numbering plan of 1947 divided the state of Texas into four numbering plan areas (NPAs) with the following area codes: 214, 512, 713, and 915. The northwestern part, stretching from the far west El Paso to the Texas Panhandle in the north and to Fort Worth in the east, was identified with area code 915, while area code 214 was assigned to the northeastern part of the state, roughly from a line just west of Dallas to Waco, to the borders of Arkansas and Louisiana.
In 1954, most of Tarrant County was combined with much of the eastern region of area code 915 to form area code 817.
Despite the growth of the Dallas metropolitan area in the second half of the 20th century, this configuration remained in place for thirty six years. In 1990, the entire eastern portion of the 214 area was split off with area code 903.
The 1990 split was intended as a long-term solution, but within five years 214 was close to exhaustion due to the rapid growth of the Metroplex as well as the popularity of cell phones, fax machines and pagers. As a remedy, all of the old 214 territory outside Dallas and Dallas County was split off with area code 972 in 1996. Within only two years, however, both 214 and 972 were on the verge of exhaustion again. Area code 469 was introduced on July 1, 1999, in an overlay plan for most of the eastern portion of the Metroplex. At the same time, the 214/972 boundary was "erased," and 972 was converted into an additional overlay for the entire region. The result was three area codes overlaying the same area, with ten-digit dialing required for all calls.
Since 2000, 214 and 972 have served as overlays for portions of eastern Tarrant County (Arlington, Bedford, Euless, Grapevine, Southlake, and Colleyville) which are closer to Dallas.
While this had the effect of allocating over 23 million numbers to an area of just over nine million people, under 2018 projections, the Dallas area would need a fourth area code by mid-2021. Area code 945 was selected as the fourth area code in the Dallas overlay, after receiving approval from the Public Utility Commission of Texas. Central office code assignments for NPA 945 have been available since January 15, 2021, but can only be requested after all existing area codes are exhausted. Current projections suggest that a fifth area code will not be needed until around 2032.




Service area


Counties served by these area codes are

Collin, Dallas, Denton, Ellis, Johnson, Kaufman, Navarro, Rockwall and generally eastern parts of Tarrant.
Towns and cities served are:

In addition, Dallas–Fort Worth International Airport is served by area code 972.




See also


List of Texas area codes
NANPA area code map of Texas




References






External links


NANPA area code map of Texas
List of exchanges from AreaCodeDownload.com, 214 Area Code
List of exchanges from AreaCodeDownload.com, 469 Area Code
List of exchanges from AreaCodeDownload.com, 972 Area Code
List of exchanges from AreaCodeDownload.com, 936 Area Code
List of All cities of 214 Area Code

Kata Kunci Pencarian:

• Daftar prefektur Jepang berdasarkan populasi
• Area codes 214, 469, 972, and 945
• List of Texas area codes
• Area codes 817 and 682
• Area code 254
• Area code 604
• List of North American Numbering Plan area codes
• Area code 979
• Area code 701
• Area code 956
• Area code 403