• Source: Adler-32

Adler-32 is a checksum algorithm written by Mark Adler in 1995, modifying Fletcher's checksum. Compared to a cyclic redundancy check of the same length, it trades reliability for speed. Adler-32 is more reliable than Fletcher-16, and slightly less reliable than Fletcher-32.




History


The Adler-32 checksum is part of the widely used zlib compression library, as both were developed by Mark Adler.
A "rolling checksum" version of Adler-32 is used in the rsync utility.




Calculation


An Adler-32 checksum is obtained by calculating two 16-bit checksums A and B and concatenating their bits into a 32-bit integer. A is the sum of all bytes in the stream plus one, and B is the sum of the individual values of A from each step.
At the beginning of an Adler-32 run, A is initialized to 1, B to 0. The sums are done modulo 65521 (the largest prime number smaller than 216). The bytes are stored in network order (big endian), B occupying the two most significant bytes.
The function may be expressed as

A = 1 + D1 + D2 + ... + Dn (mod 65521)

B = (1 + D1) + (1 + D1 + D2) + ... + (1 + D1 + D2 + ... + Dn) (mod 65521)
= n×D1 + (n−1)×D2 + (n−2)×D3 + ... + Dn + n (mod 65521)

Adler-32(D) = B × 65536 + A

where D is the string of bytes for which the checksum is to be calculated, and n is the length of D.




Example


The Adler-32 sum of the ASCII string "Wikipedia" would be calculated as follows:

A = 920 = 0x398 (base 16)
B = 4582 = 0x11E6
Output = (0x11E6 << 16) + 0x398 = 0x11E60398 = 300286872

The modulo operation had no effect in this example, since none of the values reached 65521.




Comparison with the Fletcher checksum


The first difference between the two algorithms is that Adler-32 sums are calculated modulo a prime number, whereas Fletcher sums are calculated modulo 24−1, 28−1, or 216−1 (depending on the number of bits used), which are all composite numbers. Using a prime number makes it possible for Adler-32 to catch differences in certain combinations of bytes that Fletcher is unable to detect.
The second difference, which has the largest effect on the speed of the algorithm, is that the Adler sums are computed over 8-bit bytes rather than 16-bit words, resulting in twice the number of loop iterations. This results in the Adler-32 checksum taking between one-and-a-half to two times as long as Fletcher's checksum for 16-bit word aligned data. For byte-aligned data, Adler-32 is faster than a properly implemented Fletcher's checksum (e.g., one found in the Hierarchical Data Format).




Example implementation


In C, an inefficient but straightforward implementation is :

See the zlib source code for a more efficient implementation that requires a fetch and two additions per byte, with the modulo operations deferred with two remainders computed every several thousand bytes, a technique first discovered for Fletcher checksums in 1988. js-adler32 provides a similar optimization, with the addition of a trick that delays computing the "15" in 65536 - 65521 so that modulos become faster: it can be shown that ((a >> 16) * 15 + (a & 65535)) % 65521 is equivalent to the naive accumulation.




Advantages and disadvantages


Like the standard CRC-32, the Adler-32 checksum can be forged easily and is therefore unsafe for protecting against intentional modification.
It's faster than CRC-32 on many platforms.
Adler-32 has a weakness for short messages with a few hundred bytes, because the checksums for these messages have a poor coverage of the 32 available bits.




Weakness


Adler-32 is weak for short messages because the sum A does not wrap. The maximum sum of a 128-byte message is 32640, which is below the value 65521 used by the modulo operation, meaning that roughly half of the output space is unused, and the distribution within the used part is nonuniform. An extended explanation can be found in RFC 3309, which mandates the use of
CRC32C instead of Adler-32 for SCTP, the Stream Control Transmission Protocol. Adler-32 has also been shown to be weak for small incremental changes, and also weak for strings generated from a common prefix and consecutive numbers (like auto-generated label names by typical code generators).




See also


List of hash functions




Notes






External links


RFC 1950 – specification, contains example C code
ZLib – implements the Adler-32 checksum in adler32.c
Chrome – uses an SIMD implementation of Adler-32 adler32_simd.c
RFC 3309 – information about the short message weakness and related change to SCTP

Kata Kunci Pencarian:

• Jacob Pavlovich Adler
• Mortimer J. Adler
• Max Adler (pemeran)
• Jacob Gordin
• Egon Wellesz
• Great Books of the Western World
• Makam Yusuf
• Julius Robert Oppenheimer
• Inggris
• Konfusianisme
• Adler-32
• Mark Adler
• Adler
• Cyclic redundancy check
• Fletcher's checksum
• Adler (surname)
• List of hash functions
• Rsync
• Computation of cyclic redundancy checks
• Checksum