• Source: Continuity tester

A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus.




Details


The tester consists of an indicator in series with a source of electrical power - normally a battery, terminating in two test leads. If a complete circuit is established between the test-leads, the indicator is activated.
The indicator may be an electric light or a buzzer. This led to the term "buzzing out a circuit" (which means to test for continuity) Audible continuity buzzers or beepers are built into some models of multimeter, and the continuity setting is normally shared with the ohmmeter setting.
A popular design has the tester combined with a standard flashlight. A phone connector or jack plug in the rear of the unit permits a set of test leads to be plugged in effecting a quick conversion between the two applications.
For situations where continuity testing must be done on high resistance circuits, or where delicate conductors and sensitive components that might be damaged by excessive current are present, a low voltage, low current device must be used. These typically use an op-amp and watch batteries to drive an LED as an indicator. These testers can be exquisitely sensitive; for example they will indicate if the test points are taken by both hands.
There are times when a simple continuity test fails to reveal the problem. For example, vibration-induced problems in automobile wiring can be extremely difficult to detect because a short or open is not maintained long enough for a standard tester to respond.
In these applications a latching continuity tester is used. A more complex device, it detects intermittent opens and shorts as well as steady-state conditions. These devices contain a fast acting electronic switch (generally a Schmitt trigger) forming a gated astable oscillator which detects and locks (latches) the indicator on an intermittent condition with a duration of less than a millisecond.




See also


Cable tester
Continuity test
LED circuit
Solenoid voltmeter
Test light




References






External links


Continuity Test Resistance Calculator

Kata Kunci Pencarian:

• Hewan
• Continuity tester
• Test light
• Cable tester
• Continuity test
• Tube tester
• Solenoid voltmeter
• Ground continuity monitor
• Test equipment
• Portable appliance testing
• Multimeter