- Source: Hard sectoring
Hard sectoring in a magnetic or optical data storage device is a form of sectoring which uses a physical mark or hole in the recording medium to reference sector locations.
In older 8- and 51⁄4-inch floppy disks, hard sectoring was implemented by punching sector holes in the disk to mark the start
of each sector. These were equally spaced holes, at a common radius. This was in addition to the index hole, situated between two sector holes, to mark the start of the entire track of sectors. When the index or sector hole was recognized by an optical sensor, a sector signal was generated. Timing electronics or software would use the faster timing of the index hole between sector holes, to generate an index signal. Data read and write is faster in this technique than soft sectoring as no operations are to be performed regarding the starting and ending points of tracks.
Storage formats using hard sectoring
32 sector 8-inch floppy disks
10 sector and 16 sector 51⁄4-inch floppy disks
Numerous magneto-optical formats
DVD-RAM
References
This article incorporates public domain material from Federal Standard 1037C. General Services Administration. Archived from the original on 2022-01-22.
Kata Kunci Pencarian:
- Hard sectoring
- Floppy disk format
- Sector
- Hard disk drive
- Floppy disk
- Boot sector
- Tertiary sector of the economy
- Sector 36
- History of the floppy disk
- Micropolis Corporation
