- Source: IBM 370 printer
The IBM 370 printer was used on the IBM 305 RAMAC computer system, introduced by IBM on September 14, 1956. The 370 was connected to the 305 by a serial data line from the S track of the computer's drum memory (the printer and punch both obtain information from a single output track, the control as to what information to print or punch and how, is within the print and punch units) and printed 80-columns with a punched tape controlled carriage. Line formatting was programmed by inserting wire jumpers into a plugboard control panel.
The printer mechanism used an eight sided, seven position (56 character) print slug in a horizontal orientation. The X, O, and 2 bits of the character code rotate the slug and the 1, 4, and 8 bits selected the position. The platen hammer then struck the paper from behind, causing the selected character to print. Of the 56 characters on the print slug, only 47 were printable with the standard valid character set of the IBM 305 computer—the complete alphabet, numbers 0–9, and eleven special characters (48 characters, including the blank character).
The printer can achieve the speed of 50 columns per second, with processing of 30 cards per minute; At two seconds per line can be achieved 1,800 lines per hour.
References
Kata Kunci Pencarian:
- IBM 370 printer
- List of IBM products
- IBM 305 RAMAC
- IBM 1403
- IBM remote batch terminals
- IBM System/360
- IBM hammer printers
- VM (operating system)
- IBM 3270
- Spooling
