• Source: Munitions India

Munitions India Limited (MIL) is an Indian state-owned defence company, headquartered in Pune, India, established in 2021 as part of the restructuring and corporatisation of the Ordnance Factory Board into seven different Public Sector Undertakings. Munitions India primarily manufactures ammunition, explosives, rockets and bombs for the use of the Indian Armed Forces, foreign militaries and domestic civilian use.
The budget allocated for MIL has seen increase in 2020s. The defence PSU was allocated a budget of Rs 577 crore in FY2023, Rs. 580 crore in FY2024 (RE) and Rs 745.45 crore in FY2025, highest among the seven defence PSUs. This is a part of infrastructure modernisation plan and in order to increase the war reserves of the Indian Armed Forces to sustain long-drawn wars. The sum is to be invested in modernising equipment, increasing production capacity and including new manufacturing lines for ammunition of 30mm and 40mm grenade launchers.




Products


Some notable products of Munitions India include:

Pinaka Multi Barrel Rocket Launcher
Hand Grenade
High Speed Low Drag Bomb
FSAPDS
Shivalik Multi Mode Hand Grenade (MMHG)
155 mm High Explosive Extended Range Full Bore (Boat Tail) shell
Maindeka Naval Mine
Air to Ground 1000 lb bombs (High Explosive, Thermobaric)
68 mm Air to Ground Rockets (HE, HC and Training rounds)
Mortar Bombs (81 mm, 51 mm)
Large Caliber Ammunition
155 mm (HE M-107, Illuminating rounds, HE ERFB, Screening Smoke rounds)
130 mm (HE rounds)
125 mm (HE, HEAT rounds)
105 mm (IFG HE, IFG Illuminating, Screening Smoke rounds)
Medium Caliber Ammunition
84 mm (HE, Smoke, Illuminating (ILLG) rounds)
30 mm (HE/I, AP/T, HE/T rounds for BMP-II)
Small Caliber Ammunition (20 mm rounds for anti-materiel rifle, 14.5×114mm, 7.62 x 51 mm, 7.62 x 54 mmR, 5.56 x 45 mm, 9×19 mm)




= Under Development

=



Ramjet Propelled Artillery Shell

IIT Madras along with IIT Kanpur, Armament Research and Development Establishment (ARDE) and Research Centre Imarat (RCI) are working on redesigning an existing 155 mm shell using ramjet propulsion that can cover 60 km+ range. It will be made compatible with Haubits FH77, Dhanush, K9 Vajra-T and DRDO ATAGS. The shell will use precision guidance kit for trajectory correction. IIT Madras will ensure that Munitions India can manufacture the shells.



155 mm Smart Artillery Shell

Reports emerged in February 2024, that Munitions India Limited along with Indian Institute of Technology Madras is developing the first 155 mm Smart Ammunition for the Indian Army Regiment of Artillery. The developmental time is about 2 years. The goal of this partnership is to improve artillery shell accuracy and lethality at the time of terminal impact. The munitions can be launched from 155 mm 39- and 45-calibre guns including Dhanush and DRDO ATAGS. The shells will can achieve a Circular Error Probability (CEP) of 10 m (33 ft) against the current conventional ammunitions 500 m (1,600 ft) CEP, a 50 times improvement. This will require housing of cutting-edge technologies such as miniature electronics and sensors with guidance, navigation, and control systems. The 155 mm Smart Ammunition shells will primarily utilize NavIC satellite guidance to increase accuracy and have a GPS-back up option. In order to meet different tactical needs, the 155 mm Smart Ammunition is made to work with current artillery guns and has sophisticated characteristics including fin stabilization, canard control, and a three-mode fuse operation. A minimum range of 8 km and a maximum range of 38 km are anticipated. In addition, this Smart shell has three different explosion modes: delayed, height of burst, and point detonation.




Exports


The UAE purchased 40,000 and 50,000 155 mm artillery ammunition in 2017 and 2019, respectively. In 2017 and 2019, the order was valued at approximately $40 million and $46 million, respectively. The known buyers of 155 mm shells have been the United Arab Emirates and Armenia. Unidentified European nation—likely Poland or Slovenia—just bought the artillery munitions, as per reports in February 2024.
Videos from Ukraine have recently surfaced, showing the artillery ammunition manufactured in India being used by Ukrainian forces in Russo-Ukrainian War. Social media posts in both Russian and Ukrainian languages reported what seemed to be Indian 155mm artillery shells likely falling into Ukraine. It was rumored that the weaponry consisted of MIL-produced HE ERFB BT shells.
MIL and its partner, Nadrah Company, inked a $225 million deal at World Defense Show 2024 to provide artillery ammunition to Saudi Arabia.
As of March 2024, Munitions India has export orders worth ₹6,000 crore, to be supplied till 2026-27. The leading customers are UAE, Vietnam and one undisclosed country from Europe.
In FY 2023-24, about Rs. 2,000 crores (i.e. 28.5%) of contracts of MIL was from export orders. The total business for the same time period was of Rs. 7,000 crore by value.




See also


Other PSUs formed from Ordnance Factory Board:-
Advanced Weapons and Equipment India Limited (AWE), Kanpur
Armoured Vehicles Nigam Limited (AVANI), Chennai
Gliders India Limited (GIL), Kanpur
India Optel Limited (IOL), Dehradun
Troop Comforts Limited (TCL), Kanpur
Yantra India Limited (YIL), Nagpur




References

Kata Kunci Pencarian:

• Konvensi Munisi Tandan
• Majapahit
• IAI Harpy
• KAB-500L
• IAI Harop
• Djong (kapal)
• F-20 Tigershark
• Kelulus
• Lockheed Martin F-22 Raptor
• Uranium
• Munitions India
• Yantra India
• Pinaka multi-barrel rocket launcher
• Directorate of Ordnance (Coordination & Services)
• Public Sector Undertakings in India
• List of companies of India
• Indian Armed Forces
• Food Corporation of India
• Advanced Weapons and Equipment India
• Haubits FH77