- Source: Schmidt hammer
A Schmidt hammer, also known as a Swiss hammer or a rebound hammer or concrete hammer test, is a device to measure the elastic properties or strength of concrete or rock, mainly surface hardness and penetration resistance. It was invented by Ernst Heinrich Wilhelm Schmidt, a Swiss engineer.
The hammer measures the rebound of a spring-loaded mass impacting against the surface of a sample. The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the surface, which in turn should be flat and smooth. The rebound reading will be affected by the orientation of the hammer: when used oriented upward (for example, on the underside of a suspended slab), gravity will increase the rebound distance of the mass, and vice versa for a test conducted on a floor slab. Schmidt hammer measurements are on an arbitrary scale ranging from 10 to 100.
Schmidt hammers are available from manufacturers in several different energy ranges, including (i) Type L-0.735 Nm impact energy, (ii) Type N-2.207 Nm impact energy, and (iii) Type M-29.43 Nm impact energy.
The test is also sensitive to other factors:
Local variation in the sample. To minimize this, it is recommended to take a selection of readings and take an average or median value.
Water content of the sample; a saturated material will give different results from a dry one.
Prior to testing, the Schmidt hammer should be calibrated using a calibration test anvil supplied by the manufacturer. Twelve readings should be taken, dropping the highest and lowest, and then taking the average of the ten remaining. This method of testing is classed as indirect as it does not give a direct measurement of the strength of the material. It simply gives an indication based on surface properties, and as such is suitable only for making comparisons between samples.
This method for testing concrete is governed by ASTM C805. A European standard for testing concrete in structures is EN 12504-2. ASTM D5873 describes the procedure for testing of rock.
References
External links
Screening Eagle Technologies Schmidt Hammer
Savoie Maintenance Service revendeur et réparateur SCHMIDT Hammer (in French)
Kata Kunci Pencarian:
- Katedral Cahaya Utara
- Katuaq
- ChatGPT
- Manusia
- Meta Platforms
- House of the Dragon
- Katalisis
- RB Leipzig
- Madonna
- Altar Gent
- Schmidt hammer
- Schmidt Hammer Lassen
- Schmidt
- Werner Schmidt-Hammer
- Nuuk
- Ernst Schmidt (disambiguation)
- Perkins&Will
- International Criminal Court
- Northern Lights Cathedral
- Contemporary architecture