• Source: Vehicle registration plates of Idaho

    • The U.S. state of Idaho first required its residents to register their motor vehicles and display license plates in 1913. As of 2024, plates are issued by the Idaho Transportation Department through its Division of Motor Vehicles. Front and rear plates are required for most classes of vehicles, while only rear plates are required for motorcycles and trailers.


    Passenger baseplates




    = 1913 to 1967

    =
    In 1956, the United States, Canada, and Mexico came to an agreement with the American Association of Motor Vehicle Administrators, the Automobile Manufacturers Association and the National Safety Council that standardized the size for license plates for vehicles (except those for motorcycles) at 6 inches (15 cm) in height by 12 inches (30 cm) in width, with standardized mounting holes. The 1956 (dated 1957) issue was the first Idaho license plate that fully complied with these standards: the issues from 1952 through 1955 (dated 1953 through 1956) were all 6 inches in height by 12 inches in width, but had non-standard mounting holes.


    = 1968 to present

    =


    County coding


    The current county-coding system on standard-issue Idaho license plates has been in use since 1945. The naming convention is the order of the county in an alphabetical list followed by the first letter of the county name. For example, 2T indicates the second county beginning with T in an alphabetical list, or Twin Falls County. If only one county begins with a particular letter, the letter alone serves as the county code. Specialty and vanity license plates do not use county codes; some non-passenger types are county-coded, while others are not.


    Non-passenger plates




    Government types




    Optional plates




    = Discontinued

    =


    References




    External links



    Idaho Motor Vehicle County Office Locations
    Idaho license plates, 1969–present

Kata Kunci Pencarian: